Description
Remote Car Key Suitable for Toyota RAV4 G Chip 315 MHz
It's a good way to buy a new remote key for your car.
Please check the frequency and chip of your current key
Please Note: You need to check for the "G" stamp on your original key blade.
The package includes a complete remote control car key with transponder and battery inside
Suitable for the following models:
- Toyota Rav 4 01/2010 2011 2012 2013 2014
- Toyota Tarago 10/2009 2010 2011 08/2012
- Toyota Hiace 09/2010 2011 2012 12/2013
- Toyota Corolla 10/2009 2010 2011 08/2012
Specification:
- Chip G
- Frequency 315Mhz
- Key blade TOY43
Package Content:
- 1x Complete Remote key
- 1x Battery
NOTES:
It will not work if you have a service grey key
Key blade will need to be cut (this key is uncut)
For programming, you must have one original working remote key at least
Please follow the recommended instructions!
How to program remote yourself:
Preparatory steps
With key out of the ignition sit in driver seat with driver door opened.
- 1. Within 5 seconds: Insert and remove the key from the ignition switch twice (in, out, in, out)
- 2. Within 40 seconds: Close and open driver’s door twice. Insert and remove the key from the ignition switch (in, out)
- 3. Within 40 seconds: Close and open driver’s door twice. Insert the key into the ignition switch and close the driver’s door
- 4. Within 40 seconds: Switch ignition ON and OFF once
- 5. Remove the key from ignition switch. System should now lock and unlock vehicle once
- 6. Within 45 seconds. Press and hold LOCK and UNLOCK button simultaneously for 1.5 seconds
- 7. Within 3 seconds: Press and release LOCK or UNLOCK button
- 8. System should now lock and unlock vehicle once to confirm programming, twice to indicate programming has failed
- 9. Within 45 seconds: Repeat steps 6-7 to program remaining remote transmitters
- 10. Open driver’s door to exit programming mode
To delete all programmed remotes: at Step 4, switch the ignition ON and OFF five times, locks will cycle five times. Switch the ignition ON and OFF. Open and close the driver's door.
How to program the key transponder chip:
- 1. Put the original master key in and out of the ignition 5 times. Finish with the key in the ignition
- 2. Open and close the driver's door 6 times
- 3. Remove original key from the ignition, insert the new key
- 4. Leave the new key in the ignition for 60 seconds (or till the Security light goes out on the dashboard)
- 5. After the security light stops flashing you can start the car with the new key
- 6. Remove the new key from the ignition
- 7. Open and close the door
Reviews
There are no reviews yet.