Front Blower Motor Resistor for VW Audi Seat Porsche 7L0907521B 7L0907521A 7L0907521

Front Blower Motor Resistor for Porsche Cayenne Volkswagen VW Touareg Amarok Audi Q7 Seat auto temp control replacement to fix problem with heater fan only runs at the highest speed setting (4 or 5) and doesn't work at low speeds, easy to install and replace the old or stock one

Compatibility:

• For Audi Q7 2006 – 2017
• For Seat Alhambra 2010 – 2017
• For Volkswagen VW Amarok 2011 – 2017
• For Volkswagen VW Multivan 2003 – 2015
• For Volkswagen VW Touareg 2002 – 2010
• For Volkswagen VW Transporter / Caravelle 2003 – 2015
• For Porsche Cayenne 2003 – 2010

Reference OE/OEM Number:  7L0907521B, 7L0907521A, 7L0907521, QRES7396, YL7396, 021919081D, 95557234100, 95557234101, 95557234102, JA1685

Application: Front Blower Motor

IMPORTANT NOTES:

• This blower motor resistor is designed for models equipped with standard 2-zone climate control (front left / right). 
• In models with 3- or 4-zone climate control (front + middle + rear) different or additional resistor is used (e.g., part number 3C0907521F)
• Always verify compatibility with OEM and climate control configuration before purchasing, if you are unsure, check with your dealer or local service center.

Features: 

• Front Blower Motor Resistor replace controls the speed of the blower motor and is crucial to provide air flow in your vehicle's cabin
• Innovative engineering, manufacturing technology and quality control ensure that Blower Motor Resistor meet or exceed the performance of the original equipment replace
• Every replacement Blower Motor Resistor is designed to OE fit, form and function requirements accomplished by leveraging OE expertise
• Easy to install and replace the old or stock one, direct fitment

Specification:

• Type: Front Blower Motor Resistor
• For vehicles with air conditioning
• Number of connections: 4 pin + 2 pin

How to replace a blower motor resistor?   

• Step 1: Locate the blower motor resistor. It can be found below the blower motor. In some vehicle’s you need to remove the glove compartment to access the blower motor resistor.   
• Step 2: Now that you’ve located the blower motor resistor, you’ll now need to disconnect the resistor from the housing and then remove the harness.   
• Step 3: After disconnecting the wiring harness, the blower motor resistor will easily slide out of the HVAC housing. Now install the new resistor. If the new resistor you’ve bought comes with a gasket, then make sure you remove the old gasket too. Also, some resistors do not have any type of gasket.   
• Step 4: With the new resistor in place, check if the blower motor is functioning properly. If you’re satisfied with the results, reattach the wiring harness and place it in its previous position.   
• Step 5: If you had removed the glove compartment to access the blower resistor, place it back again.  

Package includes: 1x Front Blower Motor Resistor