Remote Car Key for Toyota Corolla 2009 – 2012 G Chip 315 MHz

Remote Control Car Key Fob 315MHz 2 Button For Toyota new high-quality reliable Key replacement that will serve you for a long time and save time and money. Fully tested complete remote with a battery installed

Suitable for the following models:

• Toyota Corolla 10/2009 – 08/2012

Please Note: You need to check for the "G" stamp on your original key blade.

The package includes a complete remote control car key with transponder and battery inside.

Specification:

• Chip G
• Frequency 315Mhz 
• Key blade TOY43

Package Content:

• 1x Complete Remote key
• 1x Battery

NOTES:

• It will not work if you have a service grey key
• Key blade will need to be cut (this key is uncut)
• For programming, you must have one original working remote key at least
• Please follow the recommended instructions!

How to program remote yourself:

Preparatory steps

With key out of the ignition sit in driver seat with driver door opened.

• 1. Within 5 seconds: Insert and remove the key from the ignition switch twice (in, out, in, out)
• 2. Within 40 seconds: Close and open driver’s door twice. Insert and remove the key from the ignition switch (in, out)
• 3. Within 40 seconds: Close and open driver’s door twice. Insert the key into the ignition switch and close the driver’s door
• 4. Within 40 seconds: Switch ignition ON and OFF once
• 5. Remove the key from ignition switch. System should now lock and unlock vehicle once
• 6. Within 45 seconds. Press and hold LOCK and UNLOCK button simultaneously for 1.5 seconds
• 7. Within 3 seconds: Press and release LOCK or UNLOCK button
• 8. System should now lock and unlock vehicle once to confirm programming, twice to indicate programming has failed
• 9. Within 45 seconds: Repeat steps 6-7 to program remaining remote transmitters
• 10. Open driver’s door to exit programming mode

To delete all programmed remotes: at Step 4, switch the ignition ON and OFF five times, locks will cycle five times. Switch the ignition ON and OFF. Open and close the driver's door.

How to program the key transponder chip:

• 1. Put the original master key in and out of the ignition 5 times. Finish with the key in the ignition
• 2. Open and close the driver's door 6 times
• 3. Remove original key from the ignition, insert the new key
• 4. Leave the new key in the ignition for 60 seconds (or till the Security light goes out on the dashboard)
• 5. After the security light stops flashing you can start the car with the new key
• 6. Remove the new key from the ignition
• 7. Open and close the door